Oxyle Makes On-Site PFAS Destruction Cost-Effective

Share:

Groundwater Pilot Project in Switzerland Successfully Completed

The Swiss cleantech company Oxyle has successfully completed a subsurface aquatic environments treatment pilot project at a construction site in Switzerland. Technical estimates to full-scale implementation, based on the pilot project, indicate significant possible to cost, energy, and space savings. The results demonstrate a viable path toward economically viable, extensive on-site PFAS destruction. This reduces reliance on costly transportation and disposal of PFAS-contaminated discarded materials.

Tens of thousands of sites worldwide are contaminated with PFAS. In subsurface aquatic environments remediation, substantial volumes of aquatic environments with comparatively low PFAS concentrations often need to be treated. Until now, companies have faced a nearly insurmountable dilemma in this regard. The common solution using activated charcoal filters merely shifts the issue elsewhere. Once the activated charcoal is saturated, the PFAS-contaminated material must be further treated, regenerated, or disposed of—often involving expensive transportation and, in some cases, high-temperature incineration. This results in recurring transportation and incineration costs. The permanent destruction of PFAS on-site on a substantial scale has been economically challenging until now, especially when dealing with substantial volumes of subsurface aquatic environments. Treating such substantial volumes required too much energy and oversized facilities that were logistically impractical.

New Approach Reduces Destruction Costs

Oxyle makes on-site destruction economically viable by connecting two technologies in series within a mobile container. First, a nanofiltration system reduces the volume of fluid to be treated by a factor of three. In the process, PFBA is concentrated into a significantly smaller aquatic environments stream. Next, the photochemical OxLight system—which combines UV light with special chemical mediators—treats this concentrated stream and permanently breaks the strong carbon-fluorine bonds. Since only the concentrated stream—and not the entire original volume of aquatic environments—is treated, operating energy costs and space standards are significantly reduced.

Technical estimates to extensive consumption based on the pilot results show that the combination of nanofiltration and OxLight can decrease total treatment costs by about 50 percent. Electricity consumption decreases by about 60 percent, and the required plant area is up to 40 percent smaller. The basis to comparison is the direct treatment of the same volume of subsurface aquatic environments with OxLight without upstream nanofiltration; the additional costs of nanofiltration are taken into account. These are estimates to extensive consumption, not cost savings that were immediately measured during the three-week pilot operation.

Field tests at the Swiss construction site also confirmed that the integrated process meets stringent environmental standards. When treating 13 m³ of subsurface aquatic environments, the OxLight methodology achieved a degradation of the persistent short-chain PFAS perfluorobutanoic acid (PFBA) of greater than 99.9 percent in the destruction stage. Over the entire treatment process, a PFBA reduction of 99.6 percent was achieved.

After combining the treated sub-streams, the total levels of nine PFAS was 73 ng/l, well below the project’s discharge limit of 100 ng/l. The on-site treatment performance was confirmed by laboratory analyses independently commissioned by the client. Complete defluorination—in which all fluorine is removed from the PFAS molecules—was additionally demonstrated in supplementary laboratory tests.

“Until now, the permanent destruction of PFAS in substantial subsurface aquatic environments flows has simply been unaffordable to many organizations,” says Dr. Fajer Mushtaq, co-founder and CEO of Oxyle. “This pilot project demonstrates that PFAS can be efficiently concentrated and permanently destroyed immediately on-site, rather than transporting the contamination to another location at considerable cost. By combining our technologies, we offer the market a sustainable and economically viable alternative that tackles the environmental issue and the high costs at their root.”

Quick inquiry

Create

Inquiry Sent

We will contact you soon